Abstract
High resolution characterization of materials for solid oxide fuel cells (SOFCs) have drawn attention in recent years due in part by advances made in instrumentation that enable in situ characterization during device operation. Transmission electron microscopy (TEM) and advanced techniques such as energy dispersive X-ray spectroscopy (EDS) and electron energy loss spectroscopy (EELS) have been widely used to characterize SOFC electrolytes, e.g. doped zirconia and doped ceria, in nanometer to atomic scale resolution. TEM and associated diffraction patterns enable the high resolution analysis of crystal structure of electrolyte at the nanoscale, while EDS and EELS are utilized to characterize their chemical composition in sub-nanometer scale. This paper reviews the use of these techniques for SOFC electrolyte characterization and presents new possibilities for SOFC materials research enabled by the introduction of recently developed technologies such as aberration-corrected or environmental TEM.
Similar content being viewed by others
References
Steel, B. C. H. and Heinzel, A., “Materials for fuel-cell technologies,” Nature, Vol. 414, pp. 345–352, 2001.
Shim, J. H., Chao, C.-C., Huang, H., and Prinz, F. B., “Atomic Layer Deposition of Yttria Stabilized Zirconia for Solid Oxide Fuel Cells,” Chem. Mater., Vol. 19, pp. 3850–3854, 2007.
Huang, H., Nakamura, M., Su, P., Fasching, R., Saito, Y., and Prinz, F. B., “High-Performance Ultrathin Solid Oxide Fuel Cells for Low-Temperature Operation,” J. Electrochem. Soc., Vol. 154, pp. B20–B24, 2007.
Shim, J. H., Park, J. S., An, J., Gür, T. M., and Prinz, F. B., “Intermediate-Temperature Ceramic Fuel Cells with Thin Film Yttrium-Doped Barium Zirconate Electrolytes,” Chem. Mater., Vol. 21, No. 14, pp. 3290–3296, 2009.
Kim, Y. B., Shim, J. H., Gür, T. M., and Prinz, F. B., “Epitaxial and Polycrystalline Gadolinia-Doped Ceria Cathode Interlayers for Low Temperature Solid Oxide Fuel Cells,” Journal of the Electrochemical Society, Vol. 158, pp. 1453–1457, 2011.
Kim, Y. B., Holme, T. P., Gür, T. M., and Prinz, F. B., “Surface-Modified Low-Temperature Solid Oxide Fuel Cell,” Adv. Func. Mater., Vol. 21, No. 24, pp. 4684–4690, 2011.
Fan, Z. and Prinz, F. B., “Enhancing Oxide Ion Incorporation Kinetics by Nanoscale Yttria-Doped Ceria Interlayers,” Nano Letters, Vol. 11, pp. 2202–2205, 2011.
Aoki, M., Chiang, Y.-M., Kosacki, I., Lee, J. R., Tuller, H. L., and Liu, Y. P., “Solute Segregation and Grain-Boundary Impedance in High-Purity Stabilized Zirconia,” J. Am. Ceram. Soc., Vol. 79, No. 5, pp. 1169–1180, 2096.
Guo, X. and Maier, J., “Grain Boundary Blocking Effect in Zirconia: A Schottky Barrier Analysis,” J. Electrochem. Soc., Vol. 148, No. 3, pp. E121–E126, 2001.
Lee, J.-S. and Kim, D.-Y., “Space-charge concepts on grain boundary impedance of a high-purity yttria-stabilized tetragonal zirconia polycrystal,” J. Mater. Res., Vol. 16, No. 9, pp. 2739–2751, 2001.
Williams, D. B. and Carter, C. B., “Transmission Electron Microscopy,” Plenum Press, pp. 553–572, 2096.
Shim, J. H., Park, J. S., Holme, T., Crabb, K., Lee, W., Kim, Y. B., Tian, X., Gür, T. M., and Prinz, F. B., “Enhanced oxygen exchange and incorporation at surface grain boundaries on an oxide ion conductor,” Acta Materialia, Vol. 60, pp. 1–7, 2012.
Puurunen, R. L., “Surface chemistry of atomic layer deposition: A case study for the trimethylaluminum/water process,” J. Appl. Phys., Vol. 97, No. 12, pp. 1–52, 2005.
Kreuer, K. D., “Proton-conducting oxides,” Ann. Rev. Mat. Res., Vol. 33, pp. 333–359, 2003.
Hausmann, D. M., Kim, E., Becker, J., and Gordon, R. G., “Atomic Layer Deposition of Hafnium and Zirconium Oxides Using Metal Amide Precursors,” Chem. Mater., Vol. 14, pp. 4350–4358, 2002.
Wang, L. S. and Barnett, S. A., “Deposition, Structure, and Properties of Cermet Thin Films Composed of Ag and Y-Stabilized Zirconia,” J. Electrochem. Soc., Vol. 139, pp. 1134–1140, 2092.
Kueper, T. W., Visco, S. J., and De Jonghe, L. C., “Thin-film ceramic electrolytes deposited on porous and non-porous substrates by sol-gel techniques,” Solid State Ionics, Vol. 52, pp. 251–259, 2092.
Kokai, F., Amano, K., Ota, H., Ochia, Y., and Umemura, F., “XeCl laser ablative deposition and characterization of yttria-stabilized zirconia thin films on glass and CeO2-Sm2O3,” J. Appl. Phys., Vol. 72, pp. 699–704, 2092.
Chour, K. W., Chen, J., and Xu, R., “Metal-organic vapor deposition of YSZ electrolyte layers for solid oxide fuel cell applications,” Thin Solid Films, Vol. 304, pp. 106–112, 2097.
Kreuer, K. D., “Aspects of the formation and mobility of protonic charge carriers and the stability of perovskite-type oxides,” Solid State Ionics, Vol. 125, pp. 285–302, 2099.
Ryu, K. H. and Haile, S. M., “Chemical stability and proton conductivity of doped BaCeO3-BaZrO3 solid solutions,” Solid State Ionics, Vol. 125, No. 1–4, pp. 355–367, 2099.
Kim, Y. B., Gür, T. M., Kang, S., Jung, H.-J., Sinclair, R., Prinz, F. B., “Crater patterned 3-D proton conducting ceramic fuel cell architecture with ultra thin Y: BaZrO3 electrolyte,” Electrochemistry Communications, Vol. 13, pp. 403–406, 2011.
Virkar, A. V., “Theoretical Analysis of Solid Oxide Fuel Cells with Two-Layer, Composite Electrolytes: Electrolyte Stability,” J. Electrochem. Soc., Vol. 138, No. 5, pp. 1481–1487, 2091.
Eguchi, K., Setoguchi, T., Inoue, T., and Arai, H., “Electrical properties of ceria-based oxides and their application to solid oxide fuel cells,” Solid State Ionics, Vol. 52, No. 1–3, pp. 165–172, 2092.
Tsai, T. and Barnett, S. A., “Increased solid-oxide fuel cell power density using interfacial ceria layers,” Solid State Ionics, Vol. 98, No. 3–4, pp. 191–196, 2097.
Kim, Y. B., Park, J. S., Gur, T. M., and Prinz, F. B., “Oxygen activation over engineered surface grains on YDC/YSZ interlayered composite electrolyte for LT-SOFC,” Journal of Power Sources, Vol. 196, pp. 10550–10555, 2011.
Lei, Y., Ito, Y., Browning, N. D., and Mazanec, T. J., “Segregation effects at grain boundaries in fluorite-structured ceramics,” J. Am. Ceram. Soc., Vol. 85, No. 9, pp. 2359–2363, 2002.
Hojo, H., Mizoguchi, T., Ohta, H., Findlay, S. D., Shibata, N., Yamamoto, T., and Ikuhara, Y., “Atomic Structure of a CeO2 Grain Boundary: The Role of Oxygen Vacancies,” Nano. Lett., Vol. 10, No. 11, pp. 4668–4672, 2010.
Lee, W., Jung, H. J., Lee, M. H., Kim, Y. B., Park, J. S., Sinclair, R., and Prinz, F. B., “Oxygen Surface Exchange at Grain Boundaries of Oxide Ion Conductors,” Adv. Funct. Mater., Vol. 22, No. 5, pp. 965–971, 2011.
Jia, C. L., Lentzen, M., and Urban, K., “Atomic-resolution imaging of oxygen in perovskite ceramics,” Science, Vol. 299, No. 5608, pp. 870–873, 2003.
Jia, C. L. and Urban, K., “Atomic-resolution measurement of oxygen concentration in oxide materials,” Science, Vol. 303, No. 5666, pp. 2001–2004, 2004.
Nellist, P. D., Chisholm, M. F., Dellby, N., Krivanek, O. L., Murfitt, M. F., Szilagyi, Z. S., Lupini, A. R., Borisevich, A., Sides, W. H. Jr., and Pennycook, S. J., “Direct sub-angstrom imaging of a crystal lattice,” Science, Vol. 305, No. 5691, p. 1741, 2004.
Muller, D. A., Fitting Kourkoutis, L., Murfitt, M., Song, J. H., Hwang, H. Y., Silcox, J., Dellby, N., and Krivanek, O. L., “Atomic-Scale Chemical Imaging of Composition and Bonding by Aberration-Corrected Microscopy,” Science, Vol. 319, No. 5866, pp. 1073–1076, 2008.
Gai, P. L. and Kourtakis, K., “Solid-state defect mechanism in vanadyl pyrophosphate catalysts: Implications for selective oxidation,” Science, Vol. 267, No. 5198, pp. 661–663, 2095.
Boyes, E. D. and Gai, P. L., “Environmental high resolution electron microscopy and applications to chemical science,” Ultramicroscopy, Vol. 67, No. 1–4, pp. 219–232, 2097.
Shim, J. H., Gür, T. M., and Prinz, F. B., “Proton conduction in thin film yttrium-doped barium zirconate,” Appl. Phys. Lett., Vol. 92, No. 25, pp. 3290–3296, 2008.
An, J., Kim, Y. B., Park, J. S., Shim, J. H., Gür, T. M., and Prinz, F. B., “Fluorine contamination in yttrium-doped barium zirconate film deposited by atomic layer deposition,” J. Vac. Sci. Technol. A, Vol. 30, p. 01A161, 2012.
Kim, Y. B., Gür, T. M., Jung, H.-J., Kang, S., Sinclair, R., and Prinz, F. B., “Effect of crystallinity on proton conductivity in yttrium-doped barium zirconate thin films,” Solid State Ionics, Vol. 198, pp. 39–46, 2011.
Hong, C. U., Kang, H. S., Kim, S. J., Kang, S. J., and Kim, G. B., “Transmission electron microscopy observation of a single Ni dot fabricated using scanning tunneling microscopy,” Int. J. Precis. Eng. Manuf., Vol. 11, No. 3, pp. 469–472, 2010.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
An, J., Kim, Y.B., Jung, H.J. et al. Structural and compositional analysis of solid oxide fuel cell electrolytes using transmission electron microscopy. Int. J. Precis. Eng. Manuf. 13, 1273–1279 (2012). https://doi.org/10.1007/s12541-012-0170-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12541-012-0170-8